Petsafe Stay & Play PIF00-13672 Product Manual
  1. Manuals
  2. Brands
  3. Petsafe Manuals
  4. Pet Care Product
  5. PIF00-13672
  6. Product manual
Petsafe Stay & Play PIF00-13672 Product Manual

Petsafe Stay & Play PIF00-13672 Product Manual

Wireless fence receiver collar for stubborn dogs
Hide thumbs

Advertisement

Table of Contents

Product Manual
PIF00-13672
Stay & Play
Wireless
®
Fence Receiver Collar
for Stubborn Dogs
Please read this entire manual before beginning

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Stay & Play PIF00-13672 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Petsafe Stay & Play PIF00-13672

Summary of Contents for Petsafe Stay & Play PIF00-13672

  • Page 1 Product Manual PIF00-13672 Stay & Play Wireless ® Fence Receiver Collar for Stubborn Dogs Please read this entire manual before beginning...
  • Page 2 If you have any questions, please don’t hesitate to contact us. Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or brand of Radio Systems Corporation may be referred to collectively as “We”...
  • Page 3 CAUTION, used without the safety alert symbol, indicates a hazardous situation which, if not avoided, could result in harm to your pet. NOTICE is used to address safe use practices not related to personal injury. petsafe.com...
  • Page 4 If you are not sure that this product is right for your dog, please talk to your veterinarian or a certified trainer. • This PetSafe Stay & Play Wireless Fence ®...
  • Page 5 Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if he is not kept from crossing the boundaries, you should NOT rely solely upon the PetSafe Stay & Play Wireless ®...
  • Page 6 This product is not a toy. Keep it out of the reach of children. Proper fit of the collar is important. A collar worn for too long or made too tight on the pet’s neck may cause skin damage, ranging from redness to pressure ulcers.
  • Page 7 If so, you may relax some of these precautions. It is important to continue daily checks of the contact area. If redness or sores are found, discontinue use until the skin has fully healed. petsafe.com...
  • Page 8 • You may need to trim the hair in the area of the Contact Points. Never shave the dog’s neck; this may lead to a rash or infection. • Always remove your dog’s Receiver Collar before performing any Transmitter testing. •...
  • Page 9 Do not charge your Receiver Collar every night. Charging too often can reduce battery life. Charge your Receiver Collar when the Receiver Indicator Light blinks yellow; or when the light blinks red. petsafe.com...

  • Page 10: Key Definitions

    How the System Works The PetSafe Stay & Play Wireless Fence for Stubborn Dogs has ® ® been proven safe, comfortable, and effective for pets over 5 pounds. The system works by transmitting a radio signal up to 105 feet in all directions.
  • Page 11 Contact Points: Deliver the safe Static Light Correction when your pet moves into the Boundary Zone. Receiver Charger: Charges the Contact batteries inside the Receiver Collar Point Receiver Charge Jack: Connection point for charging Receiver battery. Receiver Charge Jack petsafe.com...
  • Page 12 Step Charge the Receiver Collar The Receiver Collar Charger is designed to plug into a standard AC wall outlet. The Receiver Collar light will glow red when the Receiver Charger is properly seated into the Receiver Charge Jack. The light will turn green when charging is complete.
  • Page 13 The rubber plug needs to remain attached to the Receiver Collar. Plug the Receiver Charger into the Receiver Charge Jack on the Receiver Collar. The Receiver Charge Jack and Receiver Charger are keyed to fit one way. Do not force it in backwards. petsafe.com...
  • Page 14 Step Prepare the Receiver Collar Your Receiver Collar comes with Short Contact Points. Use the Long Contact Points for pets with long or thick hair. Tighten the Contact Points using the Contact Point Wrench (2A). Check tightness weekly. Turning the Receiver Collar ON Press and hold the Mode Button continuously for 5 seconds (2B).
  • Page 15 OFF and all Receiver Indicator Lights will stay OFF indicating that the unit is turned OFF. To extend the time between charging the Receiver Collar, consider turning OFF the Receiver Collar when it is not in use. petsafe.com...
  • Page 16 Receiver Collar Status Indicators The Receiver Collar Status Indicator Light along with the Receiver Collar Alarm Tone are used to determine the battery status, and the correction type. Refer to the Receiver Collar Status Indicator Table below to understand the status lights and tones for the Receiver Collar. During normal operation, the Receiver Collar Indicator Light will flash every 4-5 seconds to indicate the battery status as shown in the table below.
  • Page 17 Slow blinking Collar battery charge No tone green 100%-60% (every 4-5 seconds) Slow blinking Collar battery charge No tone yellow 60%-20% (every 4-5 seconds) Collar battery charge Slow blinking red No tone 20% or less, charge (every 4-5 seconds) immediately petsafe.com...
  • Page 18 Receiver Activation Status Fast pulsating green Warning tone Warning tone (3 flashes per second Tone for Static Correction Fast pulsating red duration of being delivered (3 flashes per second) Static Correction up to 15 seconds Over Correction Protection; Continuous green No tone collar locked for (10 seconds)
  • Page 19 Correction Level Button while the Receiver Collar is on level 6 will cause the Receiver Collar to revert to level 1. Refer to the Function and Response Table to choose the Static Correction level that best fits your pet. petsafe.com...
  • Page 20 Function and Response Table Indicator Light Static Receiver Collar Response Correction Level Function 1 Red Flash No Static Correction, Tone Only 2 Red Flashes Low Static Correction 3 Red Flashes Medium-Low Static Correction 4 Red Flashes Medium Static Correction 5 Red Flashes Medium-High Static Correction 6 Red Flashes...
  • Page 21 While the system locks out further Static Correction, the green light will remain on for 10 seconds. In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Correction upon return to the Pet Area. petsafe.com...
  • Page 22 Step Fit the Receiver Collar Important: The proper fit and placement of your Receiver Collar is important for effective training. The Contact Points must have direct contact with your pet’s skin on the underside of his neck. See important safety information on pages 5-7. To assure a proper fit, please follow these steps: 1.
  • Page 23 Contact Point and your pet’s neck. The fit should be snug but not constricting (3B). Allow your pet to wear the collar for several minutes then recheck the fit. Check the fit again as your pet becomes more comfortable with the Receiver Collar. petsafe.com...
  • Page 24 6. Trim the collar as follows (3C): a. Mark the desired length of the Receiver Collar with a pen. Allow for growth if your pet is young or grows a thick winter coat. b. Remove the Receiver Collar from your pet and cut off the excess.
  • Page 25 To loosen: Slide the strap through Slide Buckle the Slide and Fasten Buckles and Fasten Buckle pull down. To tighten: Slide the strap up through the Fasten Buckle and pull through the Slide Buckle petsafe.com...
  • Page 26 Taking Your Pet Out of the Pet Area Important: Remove the Receiver Collar and leave it in the Pet Area. Once your pet learns the Boundary Zone, he will be reluctant to cross it for walks or car rides. Option 1: Replace the Receiver Collar with a regular collar. Put your pet in a car that is within the Pet Area and drive him out of the Pet Area.
  • Page 27 Battery Status Lights are flashing every 4-5 seconds administering a Static Correction. • Charge Receiver Collar • Check that the Transmitter is plugged into a working 120-volt outlet, the Power Light is on, and the Transmitter controls are set at your desired settings. petsafe.com...
  • Page 28 • Check that the Transmitter is plugged into The Receiver a working standard 120-volt outlet, the Collar is beeping Power Light is on, and the Transmitter everywhere. controls are set at your desired settings. • Bring Receiver Collar within 10 feet of the Transmitter to reset.
  • Page 29 Stubborn Dogs. The field may be affected by surrounding “electronic noise,” which can cause it to fluctuate up to 5%. • Where the Receiver Collar activates is influenced by the speed and orientation of the Receiver Collar as your pet enters the Boundary Zone. petsafe.com...
  • Page 30 • The Receiver Collar activates when it loses The Receiver Collar the Transmitter signal. This sometimes activates in the occurs if a large metal object is between middle of the yard. the Receiver Collar and Transmitter, if the orientation of the Receiver Collar changes near the Boundary Zone, or if the surrounding “electronic noise”...
  • Page 31 Dial, the Receiver Collar would no out. With the Receiver Collar within 10 feet longer beep or of the Transmitter, readjust the Boundary Control Dial and reset the Boundary Zone, correct. making sure to turn the dial down slowly. petsafe.com...
  • Page 32 • Your neighbor’s In-Ground Fence signal My next-door may interfere with the operation of the neighbor has Receiver Collar preventing activation close an In-Ground Containment to their fence. To minimize the interference, reduce the size of the Pet Area or move the System and the Transmitter away from the In-Ground Fence Receiver Collar...
  • Page 33 Receiver Collar battery to leak onto your pet’s neck. Please review and follow the important safety information on pages 6-8, and the instructions in Step 3 under the heading “Fit the Receiver Collar” on pages 22-25. petsafe.com...
  • Page 34 Test Light Instructions 1. Make sure the Receiver Collar Battery is properly charged. Set the Correction Level to 2 or above. 2. Hold the Test Light Contacts to the Contact Points. 3. Walk toward the Boundary Zone holding the Receiver Collar at your pet’s neck level until the Test Light flashes.

  • Page 35: Limitation Of Liability

    If you are unsure whether this product is appropriate for your pet, please consult your veterinarian or certified trainer prior to use. For products used with pets where training is desired, Radio Systems Corporation recommends petsafe.com...
  • Page 36 that these training products are not used if your pet is aggressive and accepts no liability for determining suitability in individual cases. 3. No Unlawful or Prohibited Use This product is designed for use with pets only. This product is not intended to harm, injure or provoke.
  • Page 37 • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and the receiver. petsafe.com...

  • Page 38: Customer Care International

    • Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. • Contact the Customer Care Center at +1 (800) 732-2677. CAUTION: Modification or changes to this equipment not expressly approved by Radio Systems Corporation may void the user’s authority to operate the equipment.

  • Page 39: Warranty

    Warranty This product has the benefit of a limited manufacturer’s warranty. Complete details of the warranty applicable to this Product and its terms can be found at petsafe.com and/or are available by contacting your local Customer Care Center. Important Recycling Advice Please respect the Waste Electrical and Electronic Equipment regulations in your country.
  • Page 40 Radio Systems Corporation 10427 PetSafe Way Knoxville, TN 37932 +1 (800) 732-2677 petsafe.com YU400-1623/3 ©2023 Radio Systems Corporation...

Table of Contents