Operation; Controller Cal3300 Built-In; Change The Setpoint; How To Select Display Resolution - Labtech DIGIBLOCK ED-S Series User Manual

Operation

Controller CAL3300 built-in

Change the Setpoint

Press and hold , the temperature of setpoint is displaying on LCD.
Press and hold , use

How to Select Display resolution

The selected temperature display is 1°C or 0.1°C, and the operation as follows.
Press and together for 3 seconds to enter program mode.
Press one time and LCD will alternatively display LEUL and 1.
Press and hold and press
Press continually until
Press and hold and press
Once the setpoint is adjusted, release the
Press and together for 3 seconds again to exit program mode.
or buttons to decrease or increase the temperature of setpoint.
one time to enter 2 and LEUL 2.
indicated on the LCD. The LCD alternatively display
or to display resolution 0.1 or 1 degree.
button.
www.labtechsrl.com
DigiBlock – User Manual
and 0.1.
Page 14 of 25