Labtech DIGIBLOCK ED-S Series User Manual page 21

D. Touch Method Check to review the method.
E. Touch Soil then Method1 to check if the program heating curve you just set is correct. Touch Save to
quit the interface and select this program.
F. In home page, touch RUN to start the selected program.
Edit another soil digestion method in Soil category, heat from room temperature to 100℃ within 15min, hold
100℃ for 60min, then increase the temperature to 150℃ within 8min, hold 150℃ for 60min. End the program.
A. In home page, touch Setup to enter Method Edit interface.
B. Touch Soil and Method2
Step 01: Touch the Temp. Text box, input 100 via the digital key. Then touch Time text box to input 15.
NOTE: Recommended temperature increasing Time is '-2' (the average heating speed is around 5℃/min), thus
the unit can heat in the max. heating speed.
Step 02: Touch the Temp. text box and input 100 via the digital key. Then touch Time text box to input 60
which means hold the temperature at previous step setpoint for 60min.
Step 03: Touch the Temp. Text box, input 150 via the digital key. Then touch Time text box to input 8 which
means temperature increase from 100C to 150C within 8min.
www.labtechsrl.com
DigiBlock – User Manual
Page 21 of 25