How To Setup Program Ramping; How To Unlock Parameters - Labtech DIGIBLOCK ED-S Series User Manual

How to Setup Program Ramping

Press and together for 3 seconds to enter program mode.
Press continually until
slope of temperature ramping 0~150℃/Hour (Temperature is ramping).
Press continually until
Press continually until
keeping time (0~1440min) after reaching the setpoint.
Press and together for 3 seconds again to exit program mode.
When and real temperature display alternatively the setup is finished. When
display alternatively the unit is running the set procedure. When STOP and real temperature display
alternatively means the temperature program ramp is finished.

How to Unlock Parameters

Press and together for 3 seconds to enter program mode.
Press one time and LCD will alternatively display LEUL and 1.
Press and hold and press
Press continually until
corresponding number.
Press and together for 10 seconds to enter LEUL 4.
When display on the LCD, press, and hold
Press and together for 3 seconds again to exit program mode. The unlock procedure is finished.
Attention Please: It is prohibited to change any other parameters that are not indicated in user
manual.
indicated on the LCD. Press and hold
indicated on the LCD. Press and hold
indicated on the LCD. Press and hold
one time to enter 3 and LEUL 3.
indicated on the LCD. The LCD alternatively display
and press
www.labtechsrl.com
DigiBlock – User Manual
and press or
and press or
and press or
and real temperature
or
to
to adjust the
to .
to adjust the
and
.
Page 15 of 25