Omron NS10-TV Series Setup Manual page 49

NS5 Rear Panel
FG Terminal
Used to prevent malfunctions
due to noise interference.
Main Circuit DC Input Terminals
Used to connect the power supply.
DIP Switch
Used to set the settings for
transmitting data using the
Memory Card.
Reset Switch
Used to initialize the PT. The status
of screen data, other registered data,
and the system menu, however, will
not change.
Serial Port B Connector
Used to connect the host, CX-
Designer, and Bar Code Reader.
Uses an RS-232C 9-pin connector.
Precautions
for Safe Use
Local Bus Interface Connector
Used to connect to an Expansion Interface Unit.
(Applicable with NS Ver. 6 or higher systems.) Current
Expansion Interface Units (NS-CA001, NS-CA002, and
NCCKL21) cannot be connected.
Battery Cover
The battery is installed
underneath the cover.
Serial Port A Connector
Used to connect the host, CX-
Designer, and Bar Code Reader.
Uses an RS-232C 9-pin connector.
Confirm system safety before turning the power ON/OFF or restarting. Other-
wise the system may operate unpredictably.
2-2 Part Names and Functions
Ethernet Connector
Used to connect the Ethernet cable.
Uses a 10Base-T/100Base-T 8-pin
modular plug.
USB Slave Connector
This is a USB Type B connector.
Refer to 3-3-2 Connecting via
USB.
USB Slave Connector
This is a USB Type B connector.
Refer to 3-3-2 Connecting via USB .
The NS5-SQ1 @@ -V2, NS5-TQ1 @@ -V2,
and NS5-MQ1 @@ -V2 can be connected
to a PictBridge-compatible printer.
(Refer to 3-5-2 Connecting a PictBridge-
compatible Printer .)
2-15