Omron NS - HOST Connection Manual page 57

ER Error response
•
Command format
ESC command
$1B E
[Settings]
*D
Error
Error contents
code
01 Illegal command
02 Command length error
03 Boundary value error
04 Illegal operand
05 Command format error
10 SUM value error
12 Reception timeout error
These commands are sent from NS to host when the host sent an invalid command
and when a communications error occurred.
20
*D SUM
R
Error codes listed below (hexadecimal 2 digits)
CR
$0D
cause
Command contents lie outside the supported
range
Length of received command is illegal for
that command.
•
Value set to parameter lies outside the
supported range.
•
Parameter in BCD format includes others
than 0 to 9
Sum information Set value lies outside
the effective range.
$W/$B command;
characters other than 0 to F and ",".
$W command; data section ends with ",".
Command with sum value ON. Computed sum
value and the one in the command do not match.
After the initial ESC was received, the interval in
between receiving one byte after the other until
command end [CR] exceeded timeout monitoring
time.
Data section includes