Omron NS - HOST Connection Manual page 35

Model CH
E5□R
Common
CH1/
CH2/
CH3/
CH4/
All CH
CH1/
CH2
*1:cannot be executed when communications writing is disabled.
When you execute an operating instruction designated to all channels, models other than the
analog output type E5ZN do not operate properly.
Title
(operating instruction)
communications writing
disabled
Communications writing
enabled
Writing mode: back up
Writing mode: RAM
Save RAM data
Reset soft
Move to setup area 1
Move to protect level
Initialize parameters
Run
Stop
Switch bank 0
Bank Switch 1
Bank Switch 2
Bank Switch 3
Bank switch 4
Bank switch 5
Bank switch 6
Bank switch 7
AT execution:selected
PID
AT execution: PID 1
AT execution: PID 2
AT execution: PID 3
AT execution: PID 4
AT execution: PID 5
AT execution: PID 6
AT execution: PID 7
At execution: PID 8
ＡＴ cancel
Auto
manual
Cancel alarm latch
SP mode: local SP
SP mode: remote SP
outline
Switch between communications writing
enabled/disabled
Select whether or not to write
operation/adjustment level
internal non-volatile memory when writing
from communications
/adjustment
Write operation
settings to internal non-volatile memory.
Reset soft
Move to setup area 1
Move to protect level
Set parameters to default values
Start control (run)
Stop control (stop)
Switch setting bank of target value, alarm
value, PID group No. setup bank
Execute AT with presently selected PID
or
with designated PID group No. PID.
Cancel AT
Select between Auto-operation/manual
operation
Cancel alarm latch
Select SP mode (local SP/remote SP).
*1
○
settings to
level
×
○
×
23