Omron NS - HOST Connection Manual page 43

3-2-2 Communications conditions setting
In NS-Designer, select tab 'Comm.-All' Serial Port A (or Serial Port B) and set to the
following communications conditions.
Parameter
Baud rate
Data bits
Stop bits
Parity
response
Notice start $B
Notice start $W
3-2-3 NS system menu operation
You can also use the NS system menu to set the communications conditions for
the Memory Link connection.
Under system menu, click tab Communications Setting.
By pressing the key beside the Serial Port A or Serial Port B, you can switch between
communications methods.
After you have thus set communications to Memory Link, use the Details key to set
the communications conditions for the Memory Link connection (for details, refer to
section 2.2). However, with system menu you cannot set the Notice start $B and
Notice start $W.
Set values are not saved until you press the Write key. Also, setting changes will be
effective when you turn the power OFF and then ON again.
6
Set value
9600bps / 19200bps / 38400bps
7 / 8
1 / 2
None / even / odd
OFF / ON
0 to 32767
0 to 32767
unused
↓
NT Link 1:1
↓
NT Link 1:N
↓
Bar code reader
↓
Temperature controller
↓
Memory Link
↓
Host Link
↓
Modem
Default value
9600bps
7
1
none
OFF
16384
16384