Download Print this page

OMRON M10-IT Instruction Manual: Selecting The User Id

Digital automatic blood pressure monitor.
Hide thumbs


3. Using the Unit

Selecting the User ID

Select your user ID. Always use the same user ID when taking a
measurement. The unit stores the measurement values in the memory
by the user ID selected. These measurement values are used to
calculate the morning averages and evening averages.
Slide the user ID selection switch up or down to select user A or B.
Using the User ID
When you select a user ID the unit can be set to take one
measurement using the single mode or three consecutive
measurements using the auto mode when you press the O/I START
Note: The default value is set to the single mode to take one
The auto mode takes three consecutive measurements. The unit will
inflate the cuff and take three measurements separated by a short
interval of time between each measurement.


   Related Manuals for OMRON M10-IT

Comments to this Manuals

Symbols: 0
Latest comments:
  • Antonio Tavares Oct 24, 2014 05:43:
    The problem is not in the Manual
    The problem is that you have to remove the batteries for more than 30 seconds to enter the sequence
    The Japanese engineer that designedth​is should coit SEPPPUKU.