Omron K3NC Manual page 22

Power ON
RUN Mode
Press the ESC Key
and Up Key for 1 s.
All key protection
Protect menu
prot
prot prot
Press the Mode
Key for 1 s.
Key-protection ON:
Key-protection OFF:
Menu display
prot prot prot
Press the Mode Key
to display the parameter.
Press the ESC Key
to return to the menu.
Note: If there is no key operation for 5 seconds, the setting is automatically registered.
C-150
Up/Down Counting Meter
Measurement stops in Protect Mode.
Depending on the output type of the model used, some parameters (indicated in
displayed (and hence cannot be set).
Protect Mode
Set value change
prohibition
sUset
sUset sUset
all
all all
(See
note.)
Displayed only for
kpon kpon
models with
kpoff kpoff comparative outputs.
Parameter display Meaning of parameter
All key protection:
All key operations are prohibited in
RUN Mode. (If all key protection is
Setting:
all all all
ON, only the key for going to Protect
Next parameter:
Mode is enabled.)
Set value change prohibition:
Changes to comparative set values
sUset sUset sUset Setting:
are prohibited in RUN Mode. (Dis-
played only for models with compara-
Next parameter:
tive outputs.)
Reset prohibition:
Resetting the counting value using
reset reset Setting:
the front panel keys is prohibited.
(Resetting by external signals is not
Next parameter:
prohibited.)
Menus protected in Setting Mode:
Setting operations in Setting Mode
Setting:
secr secr
secr
are prohibited in the way shown be-
Next parameter:
low.
Setting menu
Set value menu
Scaling menu
Setup menu
Option menu
K3NC
Maximum/minimum
Menus protected
value reset prohibition
in Setting Mode
mm.rst
mm.rst mm.rst
secr
secr secr
Note: Press the Shift Key
possible to set or change parameters.
Setting
0 1 2
to make it
Setting range
kpon kpon
Key protection ON:
kpoff kpoff
Key protection OFF:
/1/2
0 0
) are not
Setting key
(See note.)
Use the Up Key to
change the setting.
kpon kpon kpoff kpoff
➤
➤
Use the Mode Key
to enable the set-
ting and move to the
next parameter.
Use the Up Key to
change the setting.
➤ 1 1 ➤ 2 2 ➤ 3 3
Use the Mode Key
to enable the set-
ting and move to the
next parameter.