Omron K3NC Manual page 21

Protect Mode
Prescaling menu
1 s
Prescale value
bank
No key operation for 5 s
(See note 1.)
Input A prescale
value mantissa
No key operation for 5 s
(See note 1.)
Input A prescale
value exponent
No key operation for 5 s
(See note 1.)
Decimal point
No key operation for 5 s
Option menu
1 s
Power failure
memory
No key operation for 5 s
Compensation
value
No key operation for 5 s
Conditions that
allow compensa-
tion input
No key operation for 5 s
Output mode
No key operation for 5 s
Upper limit (H)
of linear out-
put range
No key operation for 5 s
Lower limit (L)
of linear out-
put range
No key operation for 5 s
Remote/local
programming
Changing Set Values
By pressing the Shift Key while a parameter is displayed, the set value can be
changed (setting status). The PROG status indicator will flash. Change the set
value as required, and press the Mode Key
the next parameter.
Setting Status
count count u-d c u-d c
If there is no key operation for 5 seconds,
Next parameter
the setting is registered and the parameter
is displayed again.
· In the Setting Mode, the measurement value is reset (i.e., to
0) and outputs turn OFF.
0
· The measurement value will be reset if the Setting Mode is
entered during measurement.
· Depending on the output type of the model used, some
parameters (indicated in
hence cannot be set).
· If the input mode is changed, all parameters will be reset to
their initial values. Set the input mode first.
Note 1: A number in the range 1 to 4 will be displayed.
/
to register the setting and move to
Change the set value using the Up
Key and the Shift Key
PROG flashes.
Setup menu
1 s
Input mode
No key operation for 5 s
Sensor type
No key operation for 5 s
Communications
unit number
No key operation for 5 s
Baud rate
No key operation for 5 s
Word bit length
No key operation for 5 s
Stop bits
No key operation for 5 s
Parity bits
) are not displayed (and
Settings displayed in reverse colors are defaults.
Up/Down Counting Meter
.
u-d u-d b b/u-d c u-d c
1200/2400/4800/
9600 /19200/38400bps
7 /8bit
1/ 2 bit
/ /
K3NC
C-149