Table of Contents
Advertisement
Display Elements
This Sensor has a Setup Mode and a Run Mode.
Setup Mode
In Setup Mode, you can set the image conditions, judgement parameters, and I/O settings for the Sensor.
The name of the mode or the
menu hierarchy is displayed.
The setup flow is shown by these five tabs.
[Image]: Used to adjust the image.
[Inspect]: Used to set the inspection items.
[In/Out]: Used to set the I/O.
[Test]: Used to test and adjust the set measurements.
[Run]: Used to switch to Run Mode.
Note
The Display Button can be used to switch between the following images.
• Live:
The live image is displayed.
• Freeze:
The image that was taken last is displayed.
• Log:
An image saved in internal memory is displayed.
• File:
An image saved on an SD card is displayed.
Run Mode
In Run Mode, measurements are performed, and measurement results are output.
p. 53
FQ Short Manual
The name of the Sensor being set up is displayed.
The selected scene number is displayed.
The menu changes according to the selected tab page.
This button menu is always displayed.
Only-image Button: Used to select either displaying the camera image and messages, or
only the camera image.
Display Button:
Used to select the source of the image or to zoom the image.
Capture Button:
Used to capture the current screen to the SD card.
Tool Button:
Used to call functions, such as saving data or select scenes.
• Buttons will appear on the right according to the mode.
• If the [
] Button appears, pressing it will display the
sub-menu or commands.
Startup Display and Display Elements
7
Advertisement
Table of Contents
