Omron FQ - SHORT Manual page 72

Important
If the cycle time is too long, the PLC may not be able to detect when the BUSY signal is ON. If necessary, turn
OFF W0.00 after a suitable time elapses.
Registering the Measurement Reference Again
The model and reference color can be re-registered with commands from an external device, such as a PLC,
based on the image that was just input when the line process was changed.
Inspection item
Search
Color data
Edge Position, Edge Width, Area
Note
• Application is possibly only from the Run Mode
• If the parameter is applicable to more than one inspection item, it will be re-registered for all inspection items.
Settings
[In/Out] − [I/O setting] − [Input] − [Input mode]
Press [Expand mode].
Wiring
Color Signal
Gray IN0
Green IN1
Red IN2
White IN3
Purple IN4
Yellow IN5
Orange OUT1 (BUSY)
70
Controlling the Sensor from an External Device
Re-registered data
Model data
Reference color (hue, saturation, and brightness)
None
State Description
OFF Command parameter for registering the model
again
OFF
OFF
ON
OFF
ON Command input for registering the model again
-- Processing in progress (default)
The signals shown at the left are
used.
Refer to the following information for
signal wiring.
2-3 Wiring: p. 15
FQ Short Manual