Connecting Peripheral Devices
2-5
Connecting Peripheral Devices
This section shows how to connect peripheral devices to the F250.
Precaution
Always turn OFF the power supply before connecting or disconnecting a
peripheral device's cable. The peripheral device may be damaged if it is con-
nected while the power is ON.
The various connectors on the F250 are capped when the F250 is shipped.
When a connector is not being used, leave the cap in place or replace the cap
to protect against dust, dirt, and static electricity.
2-5-1
Connecting a Console
Connect the Console to the F250's CONSOLE connector. An F160-KP or
F150-KP Console can be connected. Install the provided ferrite core onto the
cable, positioning the ferrite core about 10 mm from the F250-side connector.
2-5-2
Connecting a Monitor
Connect the monitor cable to the F250's MONITOR connector. Install the pro-
vided ferrite core onto the F150-VM Monitor Cable, positioning the ferrite core
about 10 mm from the F250-side connector. The S-VIDEO and VIDEO outputs
can be used simultaneously.
S-VIDEO
2-5-3
Connecting a Camera
Connect the camera cable to the F250's CAMERA connector.
CAMERA
Overview of Available Cameras
The F250 Camera with Light is a special Camera that has a special lens and
light source already attached. The light source and lens are contained in a sin-
Approx. 10 mm
CONSOLE
VIDEO
Approx. 10 mm
ESC
Ferrite core
Ferrite core
Section 2-5
SHIFT
ENT
TRIG
POWER
SYNC
17