Omron D4GS-N Datasheet

Safety-door Switch
D4GS-N
Slim Safety-door Switches
with IP67 Rating
• The slim safety-door switches with a three-terminal
contact construction.
• Reversible design allowing either front or rear mount-
ing.
• Built-in switches with two- or three-terminal contact
construction are available.
• Operation Key with rubber mounting hole to absorb
vibration and shock.
Features
Slim Safety-door Switches with 3-terminal
Contact Construction
Thin and 1/2 the size as OMRON's previous models.
30 mm 17 mm
85 mm
Reversible Design
Front and rear mounting are both possible.
Built-in Switches
Two- and three-terminal contact models are available.
Zb
Safety
contact
For safety category circuit
Safety
contact
For Programmable Controller input or indicator
Auxiliary contact
Note: The safety contacts are direct opening contacts approved by EN and
each of them is indicated with the mark
D4GS-N
Key Mounting Hole
The key mounting hole is designed with rubber to absorb vibration
and shock.
IP67 Degree of Protection
(Applicable to main body only; Operation Key insertion face
meets IP00.)
The D4GS-N uses rust-resistant materials and incorporates a drain
opening as effective countermeasures against problems caused by
water.
Note: IP67 is based on the test method specified in EN60947-5-1. Be sure to
Safety Standards
Meeting EN (TÜV) Standards and CE marking requirements along
with a variety of international standard requirements, such as UL and
CSA requirements. All NC contacts satisfy requirements for the
direct opening mechanism.
.
confirm in advance the sealing performance under the actual operating
environment and conditions.
G-163