Omron CX-SUPERVISOR - SCRIPT REFERENCE REV2.0 Reference Manual page 84

OMRON
Remarks
Argument
returnstate
TController
mode
Typical Example
temp1 = TCAutoTune("e5ak",temp2)
TCBackupMode
Syntax
returnstate = TCBackupMode(TController,mode)
Remarks
Argument
returnstate
TController
mode
Typical Example
temp1 = TCBackupMode("ea5k",temp2)
TCGetStatusParameter
Syntax
returnstate = TCGetStatusParameter(TController,paramID,value)
Revision 2.0
Type
bool Returnstate is '1' if the function is successful, or '0' otherwise.
string This is a string representing the name of the temperature
controller.
point This is a point depicting the mode of operation and defines the
operation to be carried out when a TCAutoTune command is
issued.
0: Indicates that the auto-tuning operation is to be stopped.
1: This mode is supported on the E5*K and is used to set the
limit cycle of the manipulated variable change width to 40%.
2: This is used to start the auto-tuning operation.
Type
bool Returnstate is '1' if the function is successful, or '0' otherwise.
string This is a string representing the name of the temperature
controller.
point This is a point depicting the mode of operation and defines the
method used by a temperature controller for storing internal
variables.
0: In this mode variables are stored in RAM and EPROM.
1: In this mode variables are stored in RAM only.
CHAPTER 6 – Functions and Methods
Description
Description
Page 71