Omron CX-SUPERVISOR - SCRIPT REFERENCE REV2.0 Reference Manual page 86

OMRON
Remarks
Argument
returnstate
TController
mode
Typical Example
temp1 = TCRemoteLocal("e5ak",temp2)
Note: This command was previously called TCOperationalMode.
TCRequestStatus
Syntax
returnstate = TCRequestStatus(Tcontroller, returnflag)
Remarks
Argument
returnstate
TController
returnflag
Typical Example
temp1 = TCRequestStatus("e5ak", temp2)
Note: The status information is NOT returned immediately - it is not possible to access the
status information in the same script as the TCRequestStatus command. Instead, the
status information should be accessed from within an "On Condition" script which has
an expression of "returnflag == TRUE".
TCRspLsp
Syntax
returnstate = TCRspLsp(Tcontroller,mode)
Revision 2.0
Type
bool Returnstate is '1' if the function is successful, or '0' otherwise.
string This is a string representing the name of the temperature
controller.
point This is a point depicting the mode of operation and defines the
operational mode of a temperature controller.
0: This specifies the temperature controller is in remote mode.
1: This specifies that the temperature controller is in local mode.
Type
Bool Returnstate is '1' if the function is successful, or '0' otherwise.
String This is a string representing the name of the temperature
controller.
Point This is a point depicting that the status has been returned and is
available for the command TCGetStatusParameter.
CHAPTER 6 – Functions and Methods
Description
Description
Page 73