Omron CPM2A - 11-2005 Manual page 56

Specifications
Transistor Outputs (Sinking or Sourcing)
Item
20CDT-D
20CDT1-D
Max.
OUT01000 and OUT01001:
switching
OUT01002 and up:
capacity capacity
0.8 A/common
1.6 A/Unit
(See note 2.)
Leakage 0.1 mA max.
current
Residual 1.5 V max.
voltage
ON OUT01000 and OUT01001:
delay OUT01002 and up:
OFF OUT01000 and OUT01001:
delay
OUT01002 and up:
Fuse 1 fuse/output (cannot be replaced by user)
Sinking Outputs
Circuit
configura
Output LED
tion
Internal
circuits
! Caution
36
30CDT-D 40CDT-D
30CDT1-D 40CDT1-D
4.5 to 30 VDC, 0.2 A/output (See note 1.)
4.5 to 30 VDC, 0.3 A/output
0.8 A/common 0.8 A/common
2.4 A/Unit 3.2 A/Unit
(See note 2.) (See note 2.)
20 µs max.
0.1 ms max.
40 µs max. for 4.5 to 26.4 V, 10 to 100 mA
0.1 ms max. for 4.5 to 30 V, 10 to 200 mA
1 ms max.
OUT
OUT
24 VDC/4.5 to 30 VDC
COM (–)
Note 1. When using OUT01000 or OUT01001 as a pulse output, connect a dummy
resistor as required to bring the load current between 0.01 and 0.1 A. If the
load current is below 0.1 A, the ON-to-OFF response time will be longer and
high-speed pulses (source-type transistor outputs) will not be output. If the
load current is above 0.1 A, the transistor will generate more heat and com-
ponents may be damaged.
2. The total for OUT01000 to OUT 01003 must be 0.8 A maximum. If the ambi-
ent temperature is maintained below 50 °C, however, up to 0.9 A/common
can be used.
Do not apply voltage in excess of the maximum switching capacity to an output
terminal. It may result in damage to the product or fire.
Specification
60CDT-D
60CDT1-D
0.8 A/common 0.9 A/common
4.8 A/Unit 1.8 A/Unit
(See note 2.) (See note 2.)
Sourcing Outputs
Output LED
COM (+)
Internal
OUT
circuits
OUT
Section 2-1
8ET 20EDT
8ET1 20EDT1
+10%
24 VDC
0.3 A/output
0.9 A/common
1.8 A/Unit
0.1 ms max.
1 ms max.
+10%
(24 VDC
5 to 300 mA)
1 fuse/common
(cannot be
replaced by user)
24 VDC/4.5 to 30 VDC
/ ,
–5%
/ ,
–5%