Assigning Expansion Instruction Function Codes; Setting And Reading A Program Memory Address And Monitoring I/O Bit Status - Omron CPM2A - 11-2005 Manual

Programming Console Operations

4-2-7 Assigning Expansion Instruction Function Codes

1, 2, 3...
4-2-8 Setting and Reading a Program Memory Address and Monitoring
I/O Bit Status
100
SHIFT
3. Press the SHIFT and then the 1 Key again to turn the buzzer back ON.
SHIFT
This operation is used to display or change the expansion instructions assigned
to expansion instruction function codes. The assignments can be displayed in
any mode, but can be changed in PROGRAM mode only.
Operation
Read assignment OK
Change assignment No
Assign expansion instruction function codes before inputting the program.
The CPM2A will not operate properly if expansion instructions aren't as-
signed correctly. An expansion instruction can be assigned to one function
code only.
The PC Setup must be set for user-defined expansion instruction assign-
ments. Set bits 8 to 11 of DM 6602 to 1 and turn the PC's power off and then
on again to enable the new setting.
1. Press the CLR Key to bring up the initial display.
2. Press the EXT Key to display the assignment for the first function code (17).
3. Press the Up and Down Arrow Keys to scroll through the expansion instruc-
tion function codes.
4. Press the CHG Key to assign a different expansion instruction to the selec-
ted function code.
5. Press the Up and Down Arrow Keys to scroll through the expansion instruc-
tions that can be assigned to the selected function code.
6. Press the WRITE Key to assign the displayed instruction to the function
code.
WRITE
This operation is used to display the specified program memory address and is
possible in any mode. In the RUN or MONITOR mode, the I/O bit status of bits in
the program will be displayed.
RUN
OK OK
B
1
The buzzer will not sound
when "BZ" is not displayed.
B
1
RUN MONITOR
OK
No
EXT
↓
CHG
↓
MONITOR PROGRAM
OK
Section 4-2
PROGRAM
OK
OK