Troubleshooting - Sears PRO-FORM INTERACTIVE TRAINER 585S User Manual

TROUBLESHOOTING
Most treadmill problems can be solved by following the simple steps below. Find the symptom that
applies, and follow the steps listed. If further assistance is needed, call toll-free 1-8O0-4-MY-HOME®
(1-800-469-4663).
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor,and that the surge suppressor
is plugged into a propedygroundedoutlet (see page 8). Use only a single-outletsurge suppressor
that meets all of the specifications described on page 8. Important:The treadmillis not compatible
with GFCl-equipped outlets.
b,
C.
After the power cord has been plugged in, make sure that the key is fully inserted into the console.
Check the reset/off circuit breaker located on the
treadmill frame near the power cord. If the switch
protrudesas shown, the circuit breaker has
tripped. To reset the circuitbreaker, wait for five
minutesand then press the switchback in.
Tripped
Reset_
PROBLEM: The power turns off during use
SOLUTION: a. Check the reset/off circuit breaker (see the drawing above). If the circuit breaker has tripped, wait
for five minutes and then press the switch back in.
b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for
five minutes, and then plug it back in.
c. Remove the key from the console. Reinsert the key fully into the console.
d. If the treadmill still will not run, please call toll-free 1-800-4-MY-HOME ® (1-800-469-4663).
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. With the key in the console, press one of the Inclinebuttons. While the incline is changing, re-
move the key. After a few seconds, re-insert the key. The treadmillwill automaticallyrise to the
maximumincline level and then returnto the minimumlevel. This willrecalibratethe inclinesystem.
PROBLEM: The console is too high ortoo low
SOLUTION: a. See assembly step 7 on page 7.
PROBLEM: The treadmill rocks during use
SOLUTION: a. See HOW TO LEVEL THE TREADMILL on page 20.
PROBLEM: The displays of the console do not function properly
SOLUTION: a. Remove the key from the console and UNPLUG THE
POWER CORD. With the help of a second person,
carefullytip the Upright Base (97) down as shown.
Remove the five Hood Screws (44). Note: A phillips
screwdriverwith at least a 5" shaft is required.
k _44,
_'_ t _"_ 44 '
22