Sears PRO-FORM INTERACTIVE TRAINER 585S User Manual page 19

To use programsfrom our Web site, the treadmill must
be connected to your home computer. See HOW TO
CONNECT YOUR COMPUTER on page 16. In addi-
tion, you must have an internet connection and an in-
ternet service provider. A list of specific system re-
quirements is found on our Web site.
Follow the steps below to use a program from our
Web site.
B Insert the key into the console.
See HOW TO TURN ON THE POWER on page 10.
B Select the iFIT.com mode.
When the key
is inserted,the
manua_ mode
will be se-
lected. To use
a program
from our Web
i
site, press the iFIT.com button. The iFtT.com indi-
cator will light.
B Go to your computer and start an internet
connection.
B Start your web browser, if necessary, and go to
our Web site at www.iFIT.com.
_t Follow the desired links on our Web site to se-
lect a program.
Read and follow the on-line instructions for using a
program.
r_ Follow the on-line instructions to start the
program.
When you start the program, an on-screen count-
down will begin.
B Return to the treadmill and stand on the foot
pads. Find the clip attached to the key and slide
the clip onto the waistband of your clothes.
When the on-scraen countdown ends, the program
will begin and the walking belt will begin to move.
Hold the handrails, step ontothe walking belt, and
begin walking. During the program, an electronic
"chirping" sound will alert you when the speed
and/or incline of the treadmill is about to change.
CAUTION: Always listen for the "chirp" and be
prepared for speed andlor incline changes.
If the speed or incline settings are too high or too
tow, you can manually override the settingsat any
time by pressing the Speed or Incline buttons on
the console. However, when the next "chirp" is
heard, the speed and/or incline will change to
the next settings of the program.
To stop the walking belt at any time, press the
Stop button on the console. The Time/Pace dis-
play will begin to flash. To restart the program,
press the Start button or the Speed A button. After
a moment, the walking belt will begin to move at 1
mph. When the next "chirp" is heard, the speed
and incline wilt change to the next settings of
the program.
When the program is completed, the walking belt
will stop and the Time/Pace display will begin to
flash. Note: To use another program, press the
Stop button and go to step 5.
Note: if the speed or incline of the treadmill
does not change when a "chirp" is heard, make
sure that the iFIT.com indicator is lit and that
the Time/Pace display is not flashing. In addi-
tion, make sure that the audio cable is properly
connected, that it is fully plugged in, and that it
is not wrapped around a power cord.
B Follow your progress with the track and the
displays.
See step 5 on page 10.
!_1 When the program has ended, remove the key.
See step 7 on page 13.
19