Replacing A Soldering Tip - Parkside PLP 100 A1 SOLDERING GUN Operation And Safety Notes

Switching off:
Release the ON / OFF switch
Pause: At least 48 seconds
CAUTION! Never heat up the device if it is not fitted with a sol-
dering tip.
ATTENTION! Never use in continuous operation mode. The flow
of electrical current controls the delivery of soldering heat. As soon
as the ON / OFF switch
heat drops. If the ON / OFF switch
ery of soldering heat rises. Pay particular attention to achieving an
even delivery of soldering heat to ensure the highest soldering quali-
ty. You can do this by not allowing the soldering tip
excessively hot.
Note: The device has a soldering light
ing area.
©

Replacing a soldering tip

CAUTION! DANGER OF BURNS! Allow the device to
cool down before replacing a soldering tip.
Release the two union nuts
Pull the soldering tip
Insert another tip into the holder.
Tighten the two union nuts
.
4
is released, the delivery of soldering
4
4
using the open spanner
2
or out of the holder.
1 7
using the open spanner
2
is pressed again, the deliv-
1
to illuminate the work-
3
9
Use
to become
.
9
.
GB 13