Cres Cor CGUV57A Operating And Maintenance Instructions Manual

5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Model no.
CGUV57A
HOW TO INSTALL UNIT:
1.
Place cabinet on level floor, in a well-ventilated
area.
2.
unpack and install parts for hangers or racks.
3.
Plug the cord into wall outlet.
ON/OFF
I
Switch
o
HOW TO RUN THE DECONTAMINATION CYCLE (All modes):
Read all instructions before operating the Decontamination Cabinet.
•
Turn on the device by pressing the ON/OFF Switch. The switch light will come on.
•
When the display shows the actual cabinet temperature, it's ready for use. The actual temperature is denoted
•
by 'a' next to the temperature reading.
UVc mode only
1. Once the unit is turned on, load the items evenly on the wire grids or bars as necessary.
Avoid placing items close to each other to avoid shadows.
2. Press the UVc touch button. This activates the unit's UVc light-only disinfection mode. The
numeric display will start a 15-minute timer countdown until the end of the cycle. The timer is
denoted by a 't' next to the time.
3. Once the cycle is complete, the unit beeps and displays the actual cabinet temperature.
4. The items may now be removed.
MOBILE DECONTAMINATION UVC+HEAT
Volts Watts
120 1300
UVc Only
Button
UVc + HEAT
Button
Phone: 440-350-1100 Ext: 370 • www.crescor-hs.com
Amps Hertz
12.5 60
FIRST TIME OPERATION:
1. Wipe the inside clean with detergent and hot water
Digital Display Screen
Pilot Lights
MOBILE
FL-2433
DECONTAMINATION
Rev. 6 Page
Model # CGUV57A
Phase NEMA
1 5-15P
Dial
Service Tech
Access Only
Service Tech Cancel
Access Only Button
Button
1 of 9