Using Camera Presets; Save A Camera Preset Using The Poly Tc10; Select A Preset; Delete A Preset - Polycom TC10 Admin Manual

2. From the camera drop-down menu, select a camera.
The selected camera becomes the primary camera.

Using Camera Presets

If your camera supports presets, you can save up to 10 camera positions. Camera presets are stored
camera positions that let you quickly point a camera at predefined locations in a room.
Near camera presets are available in or out of a call. Far camera presets are only available during a
call. If enabled, you can use them to control the far-site camera.
When you save a preset, the preset saves the selected camera and the camera position.
NOTE: If camera tracking is on, camera controls and presets are unavailable. Turn tracking off to
access these features.

Save a Camera Preset Using the Poly TC10

Save the current camera position as a preset for later use.
Use saved presets to change the near camera position in or out of a call. Far camera presets are
available only in a call.
1. Select Camera
2. Adjust the camera to the desired position.
3. Under Presets, do one of the following:
On an empty preset card, press the preset card.
●
To replace a preset, long press the preset card for 1 second.
●

Select a Preset

Using previously created camera presets, you can quickly move the camera to a desired position in a
call.
1. Select Camera
2. Select the image of the preset you want.

Delete a Preset

You can delete a camera preset that you no longer need.
1. Select Camera
2. Select Delete

Environment Controls

Using the Poly TC10, you can control room elements that enable you to customize your meeting
environment.
20 Chapter 4 Using the Poly TC10 in Poly Video Mode
.
.
.
.