Scep Support On Poly Touch Controllers - Polycom TC10 Admin Manual

NOTE: In paired mode, the Poly touch controller inherits these settings from the Poly VideoOS
system web interface.
1. Open a web browser and enter the touch controller IP address.
The Poly touch controller system web interface sign-in screen displays.
2. Log in using the following credentials:
Username: admin
●
Password: <last six digits of the Poly TC10/TC8 serial number>
●
NOTE:
of the Poly TC10 or Poly TC8 display.
3. Optional: Reset the password in Security > Local Accounts.

SCEP support on Poly touch controllers

You can manage certificates using your touch controller.
SCEP enables you to automatically enroll devices to retrieve new digital certificates or renew expiring
certificates. In standalone mode, enable and configure SCEP properties on your touch controller via
Poly Lens or in the touch controller web interface, go to Settings > Security > Certificates. When
paired to a Poly video system, your touch controller syncs settings automatically from your Poly
G7500 system or Poly Studio X video bar.
Configure or pair the touch controller in a staged network before moving to an 802.1x enabled
network.
In paired mode:
Settings can't be configured via the touch controller. SCEP and 802.1x settings are read-only.
●
The touch controller syncs all SCEP and 802.1x settings from the primary device.
●
Settings can either be set in the system web interface or provisioned via Poly Lens.
●
In standalone mode:
Settings can be configured via the touch controller device interface, touch controller web
●
interface, and Poly Lens.
802.1x settings can be configured through either the touch controller interface or Poly Lens.
●
NOTE: Only HTTP SCEP server URLs are currently supported. Your SCEP challenge password
must be configured as a static password. Only a single set of credentials is shared between the Poly
G7500 system or Poly Studio X video bar and the Poly touch controller.
18 Chapter 3 Setting Up the Poly TC10
The serial number is located on the sticker on the back of the device and in the settings