Table of Contents
Advertisement
Adjusting settings via the operating menu
Adjusting settings via the operating
menu
The main menu "Menu"
Synchronizing a transmitter with the diversity receiver – "Sync"
You can synchronize a suitable transmitter of the ew 100 G3 series with
the diversity receiver. During synchronization, the following parameters
are transferred to the transmitter:
• Current receiving frequency
• Current name set for the receiver ("Name", see page 16)
• Current pilot tone setting of the receiver
To transfer these parameters:
Switch the transmitter and the diversity receiver on.
On the receiver, call up the "Sync" menu item.
"Sync" appears on the display panel of the receiver.
Place the infra-red interface of the transmitter (see the instruction
manual of the transmitter) in front of the infra-red interface of the
receiver
.
The parameters are transferred to the transmitter. When the transfer
is completed, " " appears on the display panel of the diversity
receiver. The receiver then switches back to the current standard
display.
To cancel the transfer:
Press the
ON/OFF
" " appears on the display panel of the receiver. " " also appears if:
– no transmitter was found or the transmitter is not compatible,
– no transmitter was found and the synchronization process was
canceled after 30 seconds,
– you canceled the transfer.
Adjusting the squelch threshold – "Squelch"
Menu
Squelch
Low
Call up "Squelch"
Adjustment range: "Low", "Middle", "High", can be switched off
The squelch eliminates annoying noise when the transmitter is switched
off or when there is no longer sufficient transmitter power received by the
receiver.
Adjust the squelch threshold – with the transmitter switched off – to
the lowest possible setting that suppresses hissing noise.
14
("Frequency
button
on the receiver.
SET
Squelch
Low
Select the
desired setting
"Stored"
Preset", see page 15)
("Pilot
Tone", see page 18)
Squelch
Store the setting
High
SET
Advertisement
Table of Contents
