Table of Contents
Advertisement
Cleaning the diversity receiver
CAUTION!
Use a cloth to clean the diversity receiver from time to time.
Recommendations and tips
... for the diversity receiver
• Make sure that the antenna and the line cable do not cross.
• For best results, make sure that the transmitter sensitivity is correctly
adjusted.
... for optimum reception
• Transmission range depends to a large extent on location and can vary
from about 10 m to about 150 m. There should be a "free line of sight"
between transmitting and receiving antennas.
• To avoid overloading the receiver, observe a minimum distance of 5 m
between transmitting and receiving antennas.
... for multi-channel operation
• When operating a multi-channel system, you should only use the chan-
nels within one frequency bank. Each of the frequency banks "1" to
"20" accommodates factory-preset frequencies which are intermodu-
lation-free.
• The frequency bank "U" allows you to freely select and store receiving
frequencies (see page 16).
• When using several transmitters simultaneously, interference can be
avoided by maintaining a minimum distance of 20 cm between two
transmitters.
Liquids can damage the electronics of the receiver!
Liquids entering the housing of the device can cause a
short-circuit and damage the electronics.
Keep all liquids away from the receiver.
Do not use any solvents or cleansing agents.
Cleaning the diversity receiver
21
Advertisement
Table of Contents
