Displayport Module - Dell OptiPlex Small Form Factor Plus 7020 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor Plus 7020:
- Owner's manual (100 pages) ,
- Owner's manual (159 pages)
Table of Contents
Advertisement
6. Follow the procedure in
DisplayPort module
Removing the DisplayPort module
CAUTION:
The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
front
bezel.
4. Remove the
3.5-inch hard
5. Remove the
disk-drive
6. Remove the
processor fan and heat-sink
About this task
The following image indicates the location of the DisplayPort module and provides a visual representation of the removal
procedure.
Figure 56. Removing the DisplayPort module
Steps
1. Remove the two screws (M3x3) that secure the DisplayPort module to the chassis.
2. Disconnect the DisplayPort-module cable from its connector (VIDEO) on the system board.
3. Lift the DisplayPort module off the system board.
Installing the DisplayPort module
CAUTION:
The information in this removal section is intended for authorized service technicians only.
After working inside your
Before working inside your
drive, if applicable.
cage.
assembly.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
99
- Quick Links:
- Internal Slots
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex Small Form Factor Plus 7020 and is the answer not in the manual?