Installing The System Fan - Dell OptiPlex Small Form Factor Plus 7020 Owner's Manual
Hide thumbs
Also See for OptiPlex Small Form Factor Plus 7020:
- Owner's manual (100 pages) ,
- Owner's manual (159 pages)
Table of Contents
Advertisement
Figure 41. Removing the system fan
Steps
1. Disconnect the system-fan cable from its connector (FAN SYS) on the system board.
2. Gently pull the top two rubber grommets to release the fan from the chassis.
NOTE:
The rubber grommets must be re-used during system fan replacement.
3. Slide and push the bottom rubber grommets inside the chassis through the holes on the chassis .
4. Remove the system fan off the chassis.
5. Gently pull the bottom two rubber grommets from the system fan.
Installing the system fan
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
80
Removing and installing Field Replaceable Units (FRUs)
- Quick Links:
- Internal Slots
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex Small Form Factor Plus 7020 and is the answer not in the manual?
Questions and answers