Table of Contents
Advertisement
Programming using the Brand scan method
To avoid searching by entering a code or too long automatic scan, you can scan according to the
brand of the device to control. Make scanning is available only for the CD and AUDIO (HiFi)
modes.
Note: this method presumes you wish to memorize a VCR code under the VCR mode, a satellite receiver
code under the CBL mode, etc ...To memorize, for example, a VCR code under the CBL or other code, the
CBL mode key must be dedicated to the list of VCR codes.You can assign any VCR code under the CBL
mode, by applying the method described in page 8, before scanning.
1.
Switch on the device to control (TV,VCR, ...).
2.
Activate the touch screen by pressing it.
3.
Press and hold the
following screen displays (Setting screen). Release the
4.
Press the
key on the touch screen.The following screen displays (MODE screen).
CODE
5.
6.
Press one of the numeric keys (
the separate codes list).
Note: when pressing
you launch a complete scan identical to the code scanning method (see page 10).
0
7.
Press the
SEARCH
key on the touch screen (or the B or
8.
Press the
control sends a series of codes and beeps.When the device switches off or the channel
changes (according to the key pressed in step 8) press the
memorize the corresponding code.The main screen displays. Code scanning is completed.
Note: if you have accidentally overshot the code, you can browse back by pressing the
screen or the PR- key on the keypad. To move forward, press the
key on the keypad.
9.
Repeat this procedure for the other devices to control (
Note:
• point the remote control towards the device, and press the
switches off, this means the code found by the remote control is correct.You only need to check that the
various keys on the touch screen proposed enable controlling the device concerned. If touch keys are
inoperative, reprogram using make scanning, by restarting the procedure.
• When all the codes for a make have been tested, the red indicator blinks 3 times to indicate scanning is
complete, and the main screen displays.
Programming the ROC 850
6
(
) key until the red indicator remains lit (2-3 seconds) and the
SETUP
Press the mode key (
TV
2
keypad (
).The following screen displays (CODE screen).
0
to
6
) matching the make of the device to control (refer to
key on the touch screen once.The SEARCH screen displays.
SETUP
key.
,
,
...) of the device to control on the
VCR
SAT
PLAY
keys on the keypad).The remote
key (
key on the touch screen or the PR+
,
,
TV
VCR
DVD
B
key on the keypad (
9
7
) immediately to
key on the touch
,
,
).
SAT
AUX
3
). If the device
EN
EN
Hide quick links:
Advertisement
Table of Contents
