Additional Functions; Organising Channels; Pin Code Of The Digital Receiver; Aerial Supply - THOMSON ETC310 Manual

04_ETC_310_EN1 13/07/05
Once the channels set-up scan has been carried out, you can organise the list of channels memorised.
To do this, proceed as shown below
.
11:50 Page 9 (Noir/Process Black film)

Organising channels

Press on the DIGITAL key of the remote control.
Using the MENU key, display the OVERVIEW, then select the Installation line and confirm
with OK.The INSTALLATION MAIN MENU is displayed.
Select the Programme organisation line. Confirm with OK to display the menu.
Press the Yellow key (sort) to sort your channels (This allows you to access new functions).
- Press once on the Red key (name) to sort your channels in alphabetical order.
- Press once on the Green key (type) to sort your channels by their type : direct channels
first, and then encrypted channels.
An icon is displayed in front of the channel name if it is encrypted.
- Press once on the Yellow key (frequency) to sort your channels by frequency.
- Press once on the Blue key (number) to sort your channels by their number..
Once you have completed sorting your digital channels, press EXIT key as many times as
necessary to quit the menus.

PIN code of the digital receiver

This function allows you to modify the personal identification number (PIN) used to control
access to menus and channels.
Press on the DIGITAL key of the remote control.
Using the MENU key, display the OVERVIEW, then select the Installation line and confirm
with OK.The INSTALLATION MAIN MENU is displayed.
Select the installation line and display the menu by pressing on OK.
The PIN number may be asked for.
Select the PIN Code line. Confirm with OK to display the menu.
1. Using the numeric keys, enter the present PIN code and press OK.
2. Using the numeric keys, enter the new PIN code and press OK
3. Using the numeric keys, enter the new PIN code again and press OK.
4.The PIN code is now changed, press the EXIT key to quit the menu.
The default PIN number is 0000.
The first time it is modified, only steps 2 to 4 are necessary.
We recommend that write down your new PIN code and keep it in a safe place. If you lose it,
you can reset your receiver to the factory defaults but you will lose all the information that
you have previously saved.
Your personal PIN code: _ _ _ _

Aerial supply

If your aerial requires a supply via the aerial cable, do the following:
Press on the DIGITAL key of the remote control.
Using the MENU key, display the OVERVIEW, then select the Installation line and confirm
with OK.The INSTALLATION MAIN MENU is displayed.
Select the installation line and display the menu by pressing on OK.
Select the antenna powering line. Confirm with OK to display the menu.
Select ON with the
Digital reception – Additional Functions
keys.
9
EN