Connecting The Mains Plug; Installation - Hanseatic HGTI6082C14T7735ES User Manual

If the water pressure is higher than
■
this, install a pressure reducer. If in
doubt, enquire about the water pres-
sure with the water supply company.
Never connect the appliance to the
■
water tap or the mixing arm of a wa-
ter heater (continuous flow heater,
pressure-free boiler etc.).
Ensure that the inlet hose is not
■
kinked and is carefully connected.
Do not cut through the inlet hose.
■
It contains electrical components. If
the inlet hose is damaged, have it re-
placed by a specialist (see "Service"
on page EN-42).
Do not use old or previously installed
■
inlet hoses.
3
Make sure that the appliance is con-
nected to a water supply with a safety
device that prevents drinking water
from being contaminated by backflow (ac-
cording to DIN EN 1717). Connection valves
intended for this purpose must be installed
in a suitable place in a correctly installed
drinking water system in the house. If you
are unsure, consult a qualified professional.
¾ inch
Inlet hose
For water supply, you need a water tap with
a ¾-inch screw connector.
1. Screw the safety valve's lock nut to the
tap hand-tight.
2. Check that the connection to the water
tap is sealed. Turn on the water tap slow-
ly and ensure that no water is escaping.
Then close the tap again.
Installation, connection and initial commissioning

Connecting the mains plug

Risk of electric shock!
Faulty electrical installation or excessive
mains voltage may result in an electric
shock.
■
Fire hazard!
Improper handling of the appliance
can lead to fire.
■
•
•
•
•

Installation

Risk of damage to property!
Selecting the wrong screws can dam-
age the worktop.
■
WARNING
Prior to connecting the dishwasher,
ensure that you have page EN-4 tak-
en note of all the safety instructions
and adhered to them.
Never use multi-socket adapters, mul-
ti-socket strips, travel adapters or the
like.
Please ensure you only connect the de-
vice to a professionally installed protec-
tive contact socket with sufficient fuse
protection (220-240 V~/50 Hz/10 A).
Ensure that the plug is installed in such a
way that the recess into which the dish-
washer will be fitted is deep enough even
when the plug is plugged in.
Do not use a multi-socket extension ca-
ble, multi-socket plug, travel adapter, ex-
tension cable or similar.
We recommend using a pulse-sensitive
residual current device (RCD).
Insert the mains plug into the socket.
NOTICE
Use the screws which are supplied in
the delivery or screws of an appropri-
ate length.
Page EN-13