Table of Contents
Advertisement
en-us Installation and connection
3.3 Energy-saving mode
If you do not use the appliance for a brief period, it
automatically switches to energy-saving mode. All displays
go out and Start Pause flashes.
Energy-saving mode ends when you use the appliance
again.
4 Installation and connection
Installation and connection
Installation and connection
4.1 Unpacking the appliance
NOTICE:
Objects remaining in the drum that are not designed for
operation with the appliance may cause material damage
and damage to the appliance.
Remove these objects, along with all supplied
▶
accessories, from the drum before starting the
appliance.
Remove any packaging and protective covers
1.
completely from the appliance.
→ "Disposal of packaging", Page 7
Check the appliance for visible damage.
2.
Open the door.
3.
Remove any accessories from the drum.
4.
Close the door.
5.
4.2 Included in delivery
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
NOTICE:
If the appliance is operated with incomplete or defective
accessories, the appliance may not be able to operate
properly, or this may result in material damage and
damage to the appliance.
Do not operate the appliance with incomplete or
▶
defective accessories.
Replace the accessories in question before operating
▶
the appliance.
→ "Accessories", Page 22
Note: The appliance has undergone a function test at the
factory. This may cause water stains in the appliance,
which the first wash cycle removes.
The delivery consists of the following:
¡ Washing machine
¡ Accompanying documents
¡ Transit bolts
→ "Removing the transit bolts", Page 10
¡ Cover caps
¡ Water inlet hoses
→ "Connecting the water inlet hoses", Page 11
¡ Elbow for securing the water outlet hose
¡ Power adapter with fuses
8
4.3 Requirements for the installation location
WARNING
The appliance contains live parts. Touching live parts is
dangerous.
Do not operate the appliance without a cover cap.
▶
WARNING
When using the appliance on a base, the appliance may
tip over.
Always secure the feet of the appliance to a base using
▶
the manufacturer's fixing brackets → Page 22 before
using the appliance for the first time.
NOTICE:
If residual water in the appliance freezes, this may cause
damage to the appliance.
Do not install or operate this appliance anywhere that is
▶
liable to experience frost and/or outdoors.
If the appliance is tilted at an angle greater than 40°,
residual water may leak out of the appliance and cause
material damage.
Tilt the appliance carefully.
▶
Transport the appliance in an upright position.
▶
Installation location
Base
Wooden joist floor
Kitchen unit
Requirements
Secure the appliance with
fixing brackets → Page 22 .
Place the appliance on a
water-resistant wooden
board (minimum thickness
of 1.18 in. (30 mm)) which
is screwed tightly to the
floor.
Only install the appliance
underneath a continuous
countertop that is securely
connected to adjacent
cabinets. Required niche
width: 23.6 in. (60 cm).
Advertisement
Table of Contents
