Table of Contents
Advertisement
en-us Basic settings
14.2 Deactivating the control panel lock
Requirement: To deactivate the control panel lock, the
appliance must be switched on.
Press on both
3 Sec. buttons for approx. three
▶
seconds.
goes out on the display.
a
Basic settings
15 Basic settings
You can configure the basic settings for your appliance to
Basic settings
meet your needs.
15.1 Overview of the basic settings
Program selector with program positions
Set the volume of the signal tone that is emitted
2
when the program ends:
0 (off) to 4 (very loud)
Set the volume of the signal tone that is emitted
3
when the buttons are selected:
0 (off) to 4 (very loud)
No basic setting.
4
Display the number of finished programs.
5
15.2 Changing the basic settings
Set the program selector to position 1. → Page 24
1.
Press Start Pause and, at the same time, turn the
2.
program selector to position 2.
a The display shows the current value.
Use the program selector to select the required basic
3.
setting. → Page 24
Press Finish in to change the value.
4.
To save the changes, switch off the appliance.
5.
24
Cleaning and maintenance
16 Cleaning and maintenance
To keep your appliance working efficiently for a long time,
Cleaning and maintenance
it is important to clean and maintain it carefully.
16.1 Cleaning the drum
CAUTION
Permanently washing at low temperatures and a lack of
ventilation for the appliance may damage the drum and
cause injury.
Regularly run a program for cleaning the drum or wash
▶
at temperatures of Extra Hot.
Leave the appliance to dry after every operation with
▶
the door open, and leave the detergent drawer to dry.
Run the Drum Clean program without laundry but with
▶
1
washing powder that contains oxygen bleach or a a
cleaning agent for caring for the inside of the appliance.
2
→ "Accessories", Page 22
3
16.2 Cleaning the detergent drawer
4
Pull out the detergent drawer.
1.
Press down on the insert and remove the detergent
2.
5
drawer.
Pull out the insert upwards.
3.
Advertisement
Table of Contents
