Table of Contents
Advertisement
Use a 17 mm wrench to tighten the lock nuts against
3.
the housing until they are hand-tight.
In doing so, hold the appliance foot tight and do not
adjust its height.
Before using for the first time
5 Before using for the first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty washing cycle
Your appliance was inspected thoroughly before leaving
the factory. To remove any residual water, run the first
wash cycle without any laundry.
Turn the program selector to Drum Clean.
1.
Close the door.
2.
Pull out the detergent drawer.
3.
Pour approximately 4.3 cups (1 liter) of mains water into
4.
compartment II.
Before using for the first time en-us
Add washing powder containing oxygen bleach to
5.
compartment II.
To prevent foaming, use only half of the amount of
detergent recommended by the detergent manufacturer
for light soiling. Do not use detergent suitable for
woolens or delicates.
Push in the detergent drawer.
6.
Press Start Pause to start the program.
7.
a The display shows the remaining program duration.
a After the program has ended, the display shows: End.
Start the first wash cycle or set the program selector to
8.
Off to switch off the appliance.
→ "Basic Operation", Page 22
13
Advertisement
Table of Contents
