Table of Contents
Advertisement
Note: The program settings are not saved permanently for
the program.
13.4 Loading laundry
Note: To prevent creasing, note the maximum load for the
programs.
→ "Programs", Page 19
Requirements
¡ The laundry is prepared and sorted.
→ "Laundry", Page 22
¡ The drum is empty.
Open the door.
1.
Place the laundry in the drum.
2.
Close the door.
3.
Ensure that there is no laundry trapped in the door.
13.5 Adding detergent and care product
Note: Observe the information about detergents and care
products → Page 22 .
Pull out the detergent drawer.
1.
If required, use the dosing aid.
2.
Pour in the detergent.
3.
→ "Detergent drawer", Page 14
If required, add the care product.
4.
Push in the detergent drawer.
5.
13.6 Starting the program
Requirement: A program has been set.
→ "Setting a program", Page 22
Press Start Pause.
▶
a The drum rotates and load detection takes place. This
can take up to 2 minutes, after which water enters the
drum.
a The display shows the program duration or the program
end time.
a After the program has ended, the display shows: End.
13.7 Adding laundry
After the program starts, you can remove or add laundry
depending on the program status.
Press Start Pause.
1.
The appliance pauses.
Note: If you want to add laundry, follow the instructions
on the display.
→ "Display", Page 16
Open the door.
2.
Add or remove laundry.
3.
Close the door.
4.
Press Start Pause.
5.
13.8 Terminating the program
Press Start Pause.
1.
Open the door.
2.
The appliance door remains locked for safety reasons if
the temperature and water levels are high.
– If the temperature is high, start the Rinse program.
– If the water level is high, start the Spin program or
select a suitable program for draining.
→ "Programs", Page 19
Remove the laundry. → Page 23
3.
13.9 Removing the laundry
Open the door.
1.
Remove the laundry from the drum.
2.
13.10 Switching off the appliance
Turn the program selector to Off.
1.
Turn off the tap.
2.
Wipe the rubber gasket dry and remove any foreign
3.
objects.
Leave the appliance door and detergent drawer open so
4.
that residual water can evaporate.
14 Control panel lock
Control panel lock
Secure your appliance against being operated
Control panel lock
unintentionally using the controls.
14.1 Activating the control panel lock
Press on both
3 Sec. buttons for approx. three
▶
seconds.
a The display shows
.
a The control elements are locked.
a The control panel lock remains active even after the
appliance has been switched off and in the event of a
power failure.
Control panel lock en-us
23
Advertisement
Table of Contents
