Troubleshooting - AEG BES355010M User Manual

2
B
7. Pull the door trim to the front to remove it.
8. Hold the door glass panels on their top
edge one by one and pull them up out of
the guide.
9. Clean the glass panel with water and
soap. Dry the glass panel carefully. Do
not clean the glass panels in the
dishwasher.
After cleaning, do the above steps in the
opposite sequence. Install the smaller panel
first, then the larger and the door.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
Problem
The appliance does not
heat up.
The display shows
"12.00".
14 ENGLISH
1
Cause and remedy
The fuse is blown. Make
sure that the fuse is the
cause of the malfunction.
If the problem persists,
contact a qualified electri‐
cian.
There was a power cut.
Set the time of day.
Make sure that the glass panels are inserted
in the correct position otherwise the surface
of the door may overheat.
11.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
Top lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Problem
The water leaks out of the
cavity embossment.
Unsatisfying cooking per‐
formance of the function:
True Fan Cooking PLUS .
Cause and remedy
There is too much water
in the cavity emboss‐
ment. Deactivate the ap‐
pliance and make sure it
is cold. Wipe the water
with a cloth or a sponge.
Add the correct amount of
water. Refer to "Daily
use", Setting the function:
True Fan Cooking PLUS.
The cavity embossment
is not filled with water.
Add the correct amount of
water. Refer to "Daily
use", Setting the function:
True Fan Cooking PLUS.