Check Contents - JVC HR-VP672U Instructions Manual

CHECK CONTENTS
Make sure the package contains all of lhe accessories
listed in "SPECIFICATIONS" (_" pg. 53).
SITUATE VCR
Place the VCR on a slable, horizontal surface.
CONNECT VCRTO TV
The connection method you use depends on the type of
TV you have.
RF Connection
• To Connect To A TV With NO AV Input Terminals...
a- Disconnect the TV antenna from the TV.
b- Connect the "IV antenna cable to the ANT. IN jack
on the rear of the VCR.
c-Connect the supplied RF cable between the RE
OUT jack on the rear of the VCR and the TV's
antenna terminal. Set"iV on CH3 or CH4
corresponding to the CH3 - CH4 switch setting on
the back of the VCR.
AV Connection
• ToConnect TOA TVWithAVInput Terminals...
a- Connect the antenna, VCR and TV as shown in
the illustration.
I_- Connect an Audio/Video Cable between the AUDIO
OUT and VIDEO OUT jacks on the rear of the VCR
and the AV IN jacks on the "I'V.Set your TV in video
input mode or AN input mode. Refer to the TV
Instruction Manual.
For HR-VP472U Owners:
If your TV has AUDIO IN L and R connectors, connect
the VCR to the L connector,
CONNECT VCR TO
POWER SOURCE
Connect the power plug to an AC outlet.
• The clock and tuner channels will automatically he
set when the antenna isconnected and when the AC
is first connected to the VCR _ I)8. 8).
(If'Auto" or '_H" is displayed on the front display
panel before the VCR is powered on, the clock and
tuner channels are being set automatically. Wait for
the time to be displayed on the front display panel
before powering _ the VCR.)
FINALPREPARATION F OR
USE
Power on the VCR and select the VCR channel (3 or 4)
by setting the switch on the rear of the VCR as shown in
the illustration.
You can now perform simple playback (l_" pg. 16) or
simple recording (l_r pg. 17).
EN7
NOTES:
• The VCR channel is the channel on the TV which will display
the audio and video sisnals from the VCR. The VCR's CH3-
CH4 switch, on the back of the VCR, sets the VCR channel to
CH3 or CH4.
• The CH3-CH4 switch is preset to the CH3 position.
Set to CH4 if CH3 is used for broadcasting in your area and
set the channel on the TV to correspond to the VCR's CHT-
CH4 switch settinl_.
• It'RF connection to TV is used, when switching from VCR to TV
mode and frorn TV io VCR it may be necessaty to issue a CH UP
and then CH DOWN on TV to obtain a good qualitypicture.
• Even if you are using A V cables to connect your VCR to your
TV, you must also connect it using the RF cable. This will
ensure that you can record one show while watching another
(_" pg. 281.
• For full identification of the VGR's rear panel, refer to the
Index (REAR VlEVV_J" PS. 511.