Plugin Powercord - JVC HR-VP672U Instructions Manual

NUMBER "1 _
POWER
45
Control Two JVC VCRs
The remote control is capable oi controlling two JVC VCRs
independently; one set to respond to your remote control's A
code control signals and another set to respond to g code
control signals. The remote control is preset to send A code
signals because your VCR is initially set Io respond fo A code
signals. You can easily modify your VCR to respond to B code
signals.
UNPLUG VCR'S POWER
CORD
Unplug from the AC outlet.
SETREMOTECONTROL
CODE
While holding down A/B on the remote control, press
the NUMBER key '2" and then pressSTOP.
PLUGIN POWERCORD
Plug back in to the AC outlet.
TURNVCR POWERON
Press POWER on the _note.
Child Lock
This feature allows you to prevent the operation of the VCR.
TURNVCRPOWERON
Press POWER.
.ENGAGE CHILD LOCK
Press and hold POW_ on the remo_e co_'o] until the
Child Lock indicator ('--") appears on the front display
panel.
• Power turns OFF and the VCR cannot be turned on
from the POWER button on the front panel.
• To cancel Child Lock, pressand hold POWER on the
remote until the VCR turns on. During timer record-
ing, pressing TIMER also cancels Child Lock.
The VCR will now respond only to B-code commands.
To set the VCR back to respond to A code signals, repeat the
same procedure as shown above except pressing NUMBER key
"1' instead of'2" in step 2.
You can control two VCRs with the same remote control by
switching the remote's code behveen A and g (l_" Step 2).
(Ex.) To set remote control B code:
Hold Pressin succession
down
Release
NOTES:
• When Child Lock is engaged, make sure to keep the remote
control out of the reach of children.
• Diner recording o[programs that were previously set can be
performed while the Child Lock is engaged. The feature
remains in effect after the recording is finished.