Connect Network Cables; Verify Switch Operation; Perform Initial Configuration - Edge-Core ECS4100 TIP Series Quick Start Manual

4. Connect AC Power
1
Plug the AC power cord into the socket on the rear of the
1
switch.
2 Connect the other end of the power cord to an AC power
source.
Note:
For International use, you may need to change the AC
line cord. You must use a line cord set that has been
approved for the socket type in your country.

5. Verify Switch Operation

1 Verify basic switch operation by checking the system LEDs.
When operating normally, the Power and Diag LEDs should
be on green.

6. Perform Initial Configuration

1
1 Connect a PC to the switch console port using the included
console cable.
2 Configure the PC's serial port: 115200 bps, 8 characters, no
parity, one stop bit, 8 data bits, and no flow control.
3 Log in to the CLI using default settings: Username "root" and
password "openwifi."
Note:
For further information on switch configuration, refer
to the Web Management Guide and CLI Reference Guide.
1
2
3

7. Connect Network Cables

1
1 For RJ-45 ports, connect 100-ohm Category 5, 5e or better
twisted-pair cable.
2 For the SFP/SFP+ slots, first install SFP/SFP+ transceivers and
then connect fiber optic cabling to the transceiver ports. The
following transceivers are supported:
1000BASE-SX (ET4202-SX)

1000BASE-LX (ET4202-LX)

1000BASE-RJ45 (ET4202-RJ45)

1000BASE-EX (ET4202-EX)

1000BASE-ZX (ET4202-ZX)

3 As connections are made, check the port status LEDs to be
sure the links are valid.
On/Blinking Green — Port has a valid link. Blinking

indicates network activity.
On Amber — Port is supplying PoE power.

8. Initial Setup and Registration
There are two options for setting up the device for your network:
When the device is first connected to the Internet through a
network port, it is automatically redirected to ecOpen (https://
cloud.openwifi.ignitenet.com/). Enter the device's MAC address and
serial number for registration.
By default, the device is assigned an IP address through DHCP. If the
device cannot connect to ecOpen, access the device's web interface
through one of the device's RJ-45 ports to make configuration
changes (for example, to change from DHCP to a static IP). See
section "Connecting to the Web Interface".
– 2 –
Quick Start Guide
2