Resetting The Mfr Motor; Emergency Operation With A Defective Media Transport Encoder - Durst Rho P10 200 Service Manual

2 Emergency operation
2.3.3

Resetting the MFR motor

As soon as the HMD motor can be exchanged, the MFR motor must be restored to its
position, since the two motors differ in their programming.
1. Switch the printer on at the main switch.
2. Select the Communication tab.
3. To test the communication to the HMD motor, send a serial command
Response: YCMD "a"
4. To change the address of the HMD motor from a to b (MFR motor), send a serial
command
5. To set the echo mode to Full Duplex, send a serial command
6. To save changes in the motor, send a serial command
7. Switch the printer off at the main switch.
8. Exchange the MFR motor for the HMD motor.
9. Switch the printer on at the main switch.
10. Move the motors to their positions and adjust the reference switches, the head media
distance and the media feed roll unit distance ( Service Manual Settings).
2.4 Emergency operation with a defective media transport
encoder
Fig. 2: Position of the media transport encoder
1 Media transport encoder
If the media transport encoder is missing or defective, the printer can continue to print in
emergency operation. It may be necessary to select a higher print quality so as to minimise
the banding effect.
1. Activate emergency operation in the DurstPrinter.setup file: Change the value for
RhoMediaEncoderEmergencyOperation
with the respective value.
10
YCMDaDN="b" .
2014 © Durst Phototechnik DIT GmbH, Diagnostics, Edition 09.04.2014
YCMDaPR DN
YCMDbEM=0
.
YCMDbS
accordingly and insert the parameter
Rho P10 200/250
.
.