Customer Service - Bosch HSG636B 1 Series User Manual And Installation Instructions

Fault
"Sprache Deutsch" appears in
the display.
The operation does not start or is
interrupted.
Appliance does not heat up.
The time is not displayed when
the appliance is switched off.
The control ring has fallen out of
the mount in the control panel.
The control ring is difficult to turn. There is dirt below the control ring.
The control panel cannot be
opened.
Intense steam generation when
steaming.
Cause and troubleshooting
There has been a power cut.
Implement the settings for the initial configuration.
▶
– Language
– Clock
– Water hardness
Different causes are possible.
Check any notifications that appear in the display.
▶
→ "Displaying information", Page 13
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 31
Demo mode is activated in the basic settings;
Briefly disconnect the appliance from the power supply by switching the cir-
1.
cuit breaker in the fuse box off and back on again.
Deactivate demo mode within three minutes in the
2.
→ "Basic settings", Page 20.
There has been a power cut.
Open and close the appliance door once after a power failure.
▶
a The appliance is checked and is ready to use.
Basic setting has been changed.
Change the basic setting for the time display.
▶
→ "Basic settings", Page 20
The control ring has been detached.
Insert the control ring into the mount in the control panel.
1.
Push the control ring into the mount so that it clicks into place and can be
2.
turned.
The control ring can be removed.
Note: To ensure that the mount remains stable, do not remove the control ring
too often.
To loosen the control ring, press on the outer edge of the control ring.
1.
a The control ring tilts and is easier to grip.
2. Remove the control ring from the mount.
Clean the control ring and its mount on the appliance carefully using soapy
3.
water and a dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The circuit breaker is faulty.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Malfunction
Call the after-sales service.
1.
→ "Customer Service", Page 31
If there is water in the water tank, empty the water tank:
2.
Open the appliance door.
‒
Grip on the right and left below the control panel.
‒
Slowly pull out the control panel and push it upwards.
‒
The appliance is automatically calibrated.
No action required.
If the cooking times are too short, the appliance is not automatically calibrated.
If a lot of steam is generated repeatedly, the appliance is recalibrated.
Reset the appliance to the factory setting.
1.
→ "Basic settings", Page 20
Repeat the calibrations.
2.
→ "Before using for the first time", Page 11
Troubleshooting en
appears in the display.
29