D) Condensate Removal System Care; E) Door Re-Hinging; F) Adjusting The Door - Traulsen centerline CLUC-60R-SD-WTRR Owner's Manual

V. d - CONDENSATE REMOVAL SYSTEM CARE
Condensate removal is provided by evaporation at the pan
at the bottom of the equipment cabinet and does not need a
drain. The evaporator coil, condensate loop and condensate
pan, when needed, can all be flushed with fresh water by
a qualified service technician. This should be part of any
routine maintenance program and can prolong the life of the
equipment. Clean the condensate removal pan by wiping
it out with a clean damp cloth. Replace the pan back to its
location
V. e - DOOR RE-HINGING
The door(s) on all compact models can be easily re-hinged
in the field. Existing hinge cartridge and top hinge bracket
can be reused but an opposite side bottom hinge bracket
will be needed. This bracket can be obtained from the factory
by contacting our parts department (see section VIII.b) To
begin, open the door to its stay-open feature position.
Support the non-hinged end of the door so that minimum
movement occurs when the bolts from the lower hinge
brackets are removed. Remove the lower hinge bracket and
then the door from the top hinge bracket. The hinge bracket
pin and plastic bushing will remain in the top hinge bracket.
SCREWS
BOLTS
SCREWS
Fig. 11
TOP HINGE
BOLTS
SCREWS
DOOR
Fig. 12
V. CARE AND MAINTENANCE (continued)
DOOR
TOP HINGE
HINGE
CARTRIDGE BOLTS
SCREWS
DOOR
BOTTOM
BRACKET RH
PLASTIC
BUSHING
V. e - DOOR RE-HINGING (cont'd)
Carefully lay the door down on a padded flat surface. The
door must be rotated 180° to mount on the other side of
cabinet. Remove top bushing and bottom hinge cartridge
and install on opposite ends. Using the newly obtained
bottom hinge bracket, follow the steps in reverse order to
re-hinge the door.
NOTE: The lower hinge plate is under spring tension. Grasp
the lower hinge plate while keeping a firm grip on the plate,
carefully slide it out the bottom of the door just far enough
to allow the plate to rotate a full 360°. Unwind the tension
of the spring by carefully allowing the hinge plate to rotate
a full 360 degrees several times.
V. f - ADJUSTING THE DOOR
Occasionally the door(s) may require alignment adjustment.
To do so, first open the door and loosen the hinge plate
screws enough to move the hinges if desired, but the door
PLASTIC
BUSHING
is held in place. Center the door in the opening. Next level
the top hinge plate and tighten the screws. Finally, level the
lower hinge plate and tighten the screws.
-7-
Fig. 13