Trimming Outboard Motor; Adjusting Trim Angle For Hydro Tilt Models (X Transom Models) - Yamaha E60H Owner's Manual

(4) Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to " " (off).
EMU27865

Trimming outboard motor

EWM00741
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ZMU02301
1. Trim operating angle
EMU46340
Adjusting trim angle for hydro tilt
models (X transom models)
EWM00401
Stop the engine before adjusting the

trim angle.
Use care to avoid being pinched when

removing or installing the rod.
Use caution when trying a trim position

for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
There are 4 or 5 holes provided in the clamp
bracket to adjust the outboard motor trim an-
gle.
(1) Stop the engine.
(2) Tilt the outboard motor up, and then re-
Operation
1
ZMU03212
49