Checks After Starting Engine; Cooling Water - Yamaha E60H Owner's Manual

TIP:
It is not necessary to use the choke when

starting a warm engine.
Push in the main switch fully, or the remote

choke system will not operate.
(6) Turn the main switch to "
and hold it for a maximum of 5 seconds.
(7) Immediately after the engine starts, re-
lease the main switch and allow it to re-
" (on). NOTICE: Never turn
turn to "
the main switch to "
while the engine is running. Do not
keep the starter motor turning for
more than 5 seconds. If the starter
motor is turned continuously for
more than 5 seconds, the battery will
be quickly discharged, thus making it
impossible to start the engine. The
starter can also be damaged. If the
engine will not start after 5 seconds
of cranking, return the main switch to
ON
OFF
START
EMU36511
EMU36524

Cooling water

Check for a steady flow of water from the
cooling water pilot hole. A continuous flow of
ZMU02315
water from the pilot hole indicates that the
water pump is pumping water through the
cooling water passages. If the cooling water
passages are frozen, it may take a while for
water to start flowing out of the pilot hole.
ECM01811
" (start),
If water is not flowing out of the pilot hole
at all times while the engine is running,
overheating and serious damage could
occur. Stop the engine and check wheth-
ON
OFF START
er the cooling water inlet on the lower
case or the cooling water pilot hole is
blocked. Consult your Yamaha dealer if
the problem cannot be located and cor-
rected.
ZMU03753
" (start)
" " (on), wait 10 seconds, then
crank the engine again.

Checks after starting engine

Operation
[ECM00193]
ZMU03201
45