Electrical Connection - Grundig GKPN 67830 FXP User Manual

product and the ceiling, rear wall and the
side walls. Check if the rear wall clearance
protection component is present at its loca-
tion (if provided with the product). If the
component is not available, or if it is lost or
fallen, position the product so that at least
5 cm clearance shall be left between the
rear surface of the product and the wall of
the room. The clearance at the rear is im-
portant for efficient operation of the
product.
Do not use extension or multi sock-
ets in the power connection.
The manufacturer assumes no re-
sponsibility for any damage caused
by the work carried out by unau-
thorized persons.
Attaching the plastic wedges
Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the
wall.
• Remove the screws on the product and
mount the screws provided with the
wedges.
• Attach 2 plastic wedges on the ventila-
tion cover as shown in the figure.
The product's power cable must be
unplugged during installation. Fail-
ure to do so may result in death or
serious injuries!
If the door span is too narrow for
the product to pass, remove the
door and turn the product side-
ways; if this does not work, contact
the authorized service.
• Place the product on a flat surface to
avoid vibration
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to direct sun-
light or keep keep in damp environments.
Adjusting the Legs
If the product is not in a balanced position,
you can adjust the balance of the product
by rotating the stands on the front right or
left.

4.1 Electrical Connection

WARNING: Do not use extension
or multi sockets in power connec-
tion.
EN / 14
EN
FR
DE
RO