Cable Replacement - Smeg SCP496N-8 Manual

Instructions for the installer

10.2 Cable replacement

Should the supply cable need replacing,
remove the back guard by unscrewing the
screws to gain access to the terminal.
Replace the cable. The cable cross-
section must be no less than 1.5 mm² (3 x
1.5).
Make sure that the cables (for the oven or
any hob) follow the best route in order to
avoid any contact with the oven.
WARNING: The tightening torque of the screws of the terminal supply wires
must be 1.5 - 2 Nm.
10.3 Inserting the fastening bushings
To fasten the appliance correctly to the
unit, insert the bushings provided onto the
front (as shown in the figure).
Once the appliance is in place, fasten it to
the unit using the screws. The bushing
enables the screw to be angled by
approximately 30°.
After fastening the appliance, cover the
bushing with the caps provided.
88