Smeg SCP496N-8 Manual page 39

Instructions for the user
9.5 What to do if...
The oven display
completely off
The oven does not heat up •
The controls do
respond.
The cooking times
longer than those indicated
in the table.
After the automatic
"pyrolysis" cleaning cycle
(on some models only) it is
not possible to select a
function.
The display shows ERR 4
(on pyrolytic models only)
If the door is opened during
a fan-assisted function, the
fan stops.
is • Check the mains power supply.
• Check whether an omnipolar switch upstream
from the oven feed line is in the "ON" position.
Check whether it has been set in "showroom"
mode, for further details see "6.10 Secondary
menu".
not • Check whether it has been set in "child lock"
mode, for further details see "6.10 Secondary
menu".
are • Check whether it has been set in "PO" mode,
for further details see "6.10 Secondary menu".
• Verify whether the door locking device has
switched off. If it has not, the oven has a
protection device that does not allow functions
to be selected while the door locking device is
active. This is because the temperatures inside
the oven are still too high to permit any type of
cooking.
• The door lock has not properly attached to the
door. This might be because the door was
accidentally opened during the door lock
activation. Switch off the oven and switch it on
again waiting a few minutes before selecting a
new cleaning cycle.
• This is not a fault. It is a normal operation of the
appliance, useful when cooking foods in order
to avoid excessive heat escaping. When the
door is closed, the oven will return to normal
operation.
85