Instructions for the installer
10.2 Cable replacement
Should the supply cable need replacing, remove
the back guard by unscrewing the screws to gain
access to the terminal.
Replace the cable. The cable cross-section must
be no less than 1.5 mm² (3 x 1.5) (see 10.1
Electrical connection).
Make sure that the cables (for the oven or any hob)
follow the best route in order to avoid any contact
with the oven.
WARNING: The tightening torque of the screws of the terminal supply wires
must be 1.5 - 2 Nm.
63