Smeg SC381X-8 Manual page 28

Lift up the edge of the lower heating
element a few centimetres and clean
the bottom.
Put the pizza plate support back in
place, pushing it in until it hits the back
of the oven, and push it down so that
the heating element plate is embedded
into the base itself.
When the operation is complete, damp parts should be dried thoroughly.
9.5.1 Removing the guide frames (on some models only)
Removing the guide frames makes it easier
to clean the side parts, and it also needs to
be done whenever the automatic cleaning
cycle is used (only available on some
models).
• To remove the guide frames, pull the
frame towards the inside of the oven to
unhook it from its housing A, then slide
it out of the seats at the back B.
• When cleaning is complete, repeat the
above procedures to put the guide
frames back in.
70
Instructions for the user